Than 25km/hr, auto landing: lower than 15km/hrīattery Storage : Suggest wind speed: GPS & RTL mode: lower than 20km/hr, altitude mode: lower.Quick clip on platform for optional module.Motors (up to 40mm size), batteries & propellers (up to 12.5 in) are upgradable.Propeller: 11”x 4.5”CW & CCW folding Propeller.Battery: 4S / 5200mAh, 15C battery pack with XT60 connector.(With 4S 5,200mAh battery, take-off weight 1,200g) Payload Capability: 1,000g (Include: battery(s), camera, gimbal, FPV….Empty RTF weight: 985g (Fully assembled, battery not attached.).(Various motors are available as option for higher Maximum motor to motor dimension: Ø 567.0mm.Propeller extended): 842.0mm x 842.0mm x H Ready to fly dimensions (Propeller folded): 609.0mm x 609mm x H 195.0mm.Carry & storage dimensions: 215mm x 215mm x H 195mm.The Quad-copter :The Quad-copter Specifications : (The picture below shows an example of mode2 ) This means no matter where the vehicle is, pulling the pitch back will cause it to return towards home regardless of the vehicle’s actual heading. It uses the vehicle’s position relative to home instead of the vehicle’s initial heading when it was armed.
■ Intelligent altitude mode – designed for flight beyond visual range. The orange propellers point to the front. Is based on the orientation of the Quad-copter’s heading.
When “GPS hold” is turned on, the Quadcopter can’t takeoff if the GPS signal is too weak. ■ GPS hold - When GPS is located, this function will hold the Quadcopter where it is. A 3-position switch, at the top right corner of the remote control, controls 3 flight modes: GPS Hold (for outdoor), Altitude Hold (no GPS signal/indoor), and Return to “Launch point”.(Mode 1: right-hand throttle, Mode 2: left-hand throttle) A mode switch near the middle of the bottom of the remote control can change the stick mode between Mode 1 / Mode 2. The 2 control sticks control the 4 Axis (Roll, Pitch, Yaw, Up/Down) flight control.An 8 Channel radio control system has control range about 1000 meters, (depends on circumstances).
#MANUAL FOR FLEXIFY DRONE 32 BIT#
■ A flight controller which is powered by a 32 bit MCU.■ An integrated sensor module including accelerometer, gyro, compass &īarometer sensors.■ A GPS module.■ Four sets of speed controllers, motors, and foldable self-tighten CW & CCW 5200Ah 4S LiPo Battery (may change or remove depended on final configurationīasic Function Introduction : AC-DC Adaptor (may change or remove depended on final configuration forĥ. DC-DC Charger (may change or remove depended on final configuration forĤ.
#MANUAL FOR FLEXIFY DRONE INSTALL#
IndexWhat’s included?.3Basic Function Introduction.3The Remote Control.7Function Description.8How to achieve the maximum distance?.9 The Quadcopter.10 The Quad-copter Specifications.10 Un-fold the Quadcopter.12 Fold the Quadcopter.13Charging the battery.13Battery Storage.14Flight.14 Install the battery pack.14Arm & disarm the motors.14 Motor arming.14 Disarm the motors.15 GPS hold.15 Altitude hold.15Return to “Launch point”.16Intelligent altitude mode.17Fail safe.17 Low battery fail safe.17DISCLAIMER & WARNING.18INSTRUCTIONS.18 CAUTIONS.19 USING BATTERY.20 LIMITATION OF LIABILITY.20 WARNING.22 NOTE.22Relative information download.24
0 kommentar(er)
